CORONA TREATMENT

WHY CORONA TREATMENT IS ESSENTIAL TO YOUR BUSINESS

The problem with writing or printing on plastic films is well known. You have a plastic bag and you would like to write on it with a pen, but unfortunately the ink doesn’t stick to the plastic since the untreated plastic has a structure, which makes it impossible to both write and print on due to poor adhesion. Corona treatment is the solution to this well know problem.

Corona treatment is a high frequency discharge that increases the adhesion of a plastic surface.

 

This High Frequency Generator produces a (tesla coil) high voltage, high frequency spark at the tip of an electrode.  The electric field created around the electrode is used for surface treating of polymers and other substrates.

The Power Supply is furnished with a polarized and grounded power line cord 6-feet in length.  Operation is from 115 volts, 50/60 Hz, and 230 volts, 50/60 Hz for the EU model.

OUTPUT VOLTAGE:  10,000 to 50,000 volts regulated by adjustment knob

 

HOW TO AVOID ADHESION PROBLEMS

The pre-treatment offered by Cornoa treatment is necessary to obtain sufficient wetting and adhesion on plastic films or metallic foils before the printing, laminating or coating. A Corona discharge unit is the solution to optimize the wetting and adhesion. This Corona technique has proved to be both highly effective, cost-effective and can take place in-line.

BD20-AC A laboratory Corona Surface Treater used primarily in research laboratories where the studying of corona treating effects takes place. This model can be used in low volume production work for treating very small parts. Not intended for continuous use.

BD20-ACV [International Models] – In Stock

$782 + Freight

  • ETP SKU #:12051A-10 (US Model 120 VAC w/Line Filter, 115V)